CP96SDB50-250C 日本SMC气缸/标准型主要参数
日本SMC气缸/标准型主要参数内置磁环 D 无磁性开关(内置磁环)安装方式 B 基本型缸径 50 缸径 50mm气缸行程 250 气缸行程 250mm...
日本SMC气缸/标准型主要参数
产品作用:
进行雾化并注入空气流中,随压缩空气流入需要润滑的部位,达到润滑的目的..
不给油润滑已很普遍而给油润滑逐渐减少将润滑油
In the range of the use of the maximum load in the
cylinder is swift, this is dangerous.Fo
three-bit (Notin the sealed gap seal type) solenoidvalve before starting
horizo
本端锁型气缸的控制使用二位四五通电磁阀应避免使用三位
following diagram in the co
水平方向安大负载重以下在下图的范围内使气缸的速度
会发生指示灯的可视性低下也有出现不能显示的场合
调整应使用速度控制阀返回侧必须供气
形成背压气缸内处于排气在伸出侧一旦供气气缸会急速动作这是危险的
cylinder speed adjustment should be used speed co
别是中封式间隙密封型)电磁阀起动前在
Thereturn side must be supplied with air to form the
ackpressure cylinder in the exhaust on the extension side. o
rvertical铅垂方向安装的场合负载质量和气缸速度应在下图
Theuse of two-position four-way solenoid valve to avoid the use of
无触点耐弯曲规格在导线长度的后面记入-61围内使用
installation, the load mass and cylinder speed suld be shown in the following figure
日本SMC气缸/标准型主要参数
日本SMC气缸/标准型主要参数
如果您觉得“CP96SDB50-250C 日本SMC气缸/标准型主要参数”描述资料不够齐全,请联系我们获取详细资料。(联系时请告诉我从仪器交易网看到的,我们将给您最大优惠!)
本页链接:http://www.yi7.com/com_shqt8808/sell/itemid-6728597.html
已经有1174位访客查看了本页.